Filter
Top Products
3 • Operation and Maintenance
Doc. 065291-01 3/09 51
3.2 Turning On the System Power
Press the power switch on the ICS-
2100 rear panel (see Figure 3-3
) to
turn on the system power. Table 3-4
shows the ICS-2100 conditions at
power-up.
Also turn on the power to the
computer and the autosampler (if
used).
Figure 3-3. ICS-2100 Rear Panel
Feature Power-Up Condition
Pump Off
Injection valve Load position
Cell Reading current value
Suppressor Off*
Cell heater Set to the last value used. The default when the ICS-2100
is turned on for the first time is 35 °C.
Column oven temperature Set to the last value used. The default when the ICS-2100
is turned on for the first time is 30 °C.
Eluent generator Off*
CR-TC Off
EPM
Off
*
* When you start the suppressor, eluent generator, or EPM, the value used last is restored.
Table 3-4. ICS-2100 Power-Up Conditions
Power
Switch