Filter
Top Products
5•Service
Doc. 065291-01 3/09 191
4. Thread the three lines from the EPM (red, yellow, and blue labels)
through the opening on the side of the new holder (see Figure 5-80
).
5. Turn the new EGC holder
upside down (see
Figure 5-81
).
NOTE To help retain the
fittings and ferrules
on the lines, remove
the coupler from each
line just before
connecting the line to
a port.
Figure 5-81. EGC Holder (upside down)
6. Connect the lines from the EPM (red, yellow, and blue labels) to the
corresponding lines in the holder.
7. Disconnect the line labeled
TO CR-TC/EPM REGEN IN (orange label)
from the
REGEN IN port on the EPM and connect the new TO CR-
TC/EPM REGEN IN
line (orange label) to the port.
Figure 5-80. TO CR-TC/EPM Lines Outside of Holder
TO CR-TC/EPM
ELUENT OUT
(yellow label)
TO CR-TC/EPM
ELUENT IN
(red label)
TO CR-TC/EPM
REGEN OUT
(blue label)