Filter
Top Products
ICS-2100 Ion Chromatography System
16 Doc. 065291-01 3/09
2.1.2 Top Cover
Figure 2-7 illustrates the top cover of the ICS-2100.
EluGen Cartridge and Reservoir
Storage
The top cover holds one or two
EluGen
®
cartridges and up to
two 2-L plastic reservoirs
(P/N 044129) or one 4-L plastic
reservoir (P/N 039164).
EluGen Cartridges
The EluGen cartridges are
installed in holders that fit into
the two back reservoir areas.
See Section 2.4.4
for details
about the eluent generator.
Tubing Chase
The tubing chase under the
EGC and CR-TC connectors
routes tubing from the eluent
reservoir and EGC holder to the
front of the ICS-2100.
Figure 2-7. ICS-2100 (Top View)
EGC, EPM, CR-TC, and Auxiliary Power Supply Connectors
The cable from the EluGen cartridge (EGC) connects to the EGC-1
connector. The cable from the Continuously Regenerated Trap Column
(CR-TC) connects to the
CR-TC connector. If a second EluGen cartridge is
installed, it connects to the
EGC-2 connector. If the second eluent
generator power supply is configured to power an auxiliary electrolytic
device, it connects to the
EGC-2 connector. For details, refer to the ICS-
2100 installation instructions.
When operating with an EGC II K
2
CO
3
EluGen Cartridge and the EPM
Electrolytic pH Modifier, the EluGen cartridge is typically connected to
the
EGC-1 connector. The pH modifier, which mounts on the side of the
Deionized
Water
EluGen
Cartridge
and Holder
EGC, EPM,
CR-TC, and
Auxiliary
Power
Supply
Connectors
Tubing
Chase
(under
connectors)
EGC Service
Area
4 L
Reservoir
Area
Second
EluGen
Cartridge or
Reservoir
Area