Filter
Top Products
B • Touch Screen Operation
Doc. 065291-01 3/09 235
B.12 Module Setup Page
The MODULE SETUP page lets you select options for the touch screen display and
conductivity readings. To open this page, select
SETUP from the menu of pages.
Module Setup Options
• Backlight Duration: Select 2-hour time-out to turn off the backlight after
2 hours if the touch screen is not used during that time. Select
Always On to
have the backlight remain on continuously.
• Screen Time-out: If the touch screen is not used
during the selected time-out, the display will
change to show the screen selected from the list.
For example, if you select
5 min and BUSY, the
display will change to the
BUSY page (see
Figure B-10
) 5 minutes after the last time the
touch screen was used. Select
Never to always
display the page that was used last.
• Conductivity Display: Select either Offset (the
default setting) or
Total as the primary
conductivity display value. The selected value is
shown in large bold type on the
HOME and STATUS screens, with the other
value in smaller type.
Figure B-21. Module Setup Page
Time-out
options
to screen
options
Change