Filter
Top Products
Procedure
Select the language you want to use.
Tip
For devices with the Chinese-language display, you can use a shortcut key, or an optical switch
combination, to change the language without having to access the display menu. The optical switch
combination is shown on the front of the display.
The languages available depend on your transmitter model and version.
5.1.2 Configure the process variables shown on the display
Display (standard) Not available
Chinese-language
display
Not available
ProLink II ProLink > Configuration > Display
ProLink III Device Tools > Configuration > Transmitter Display > Display Variables
Field Communicator Configure > Manual Setup > Display > Display Variables
Overview
You can control the process variables shown on the display and the order in which they
appear. The display can scroll through up to 15 process variables in any order you choose.
In addition, you can repeat variables or leave slots unassigned.
Restrictions
• You cannot set Display Variable 1 to None. Display Variable 1 must be set to a process variable.
• If you have configured Display Variable 1 to track the primary mA output, you cannot change
the setting of Display Variable 1 using this procedure. To change the setting of Display Variable 1,
you must change the configuration of mA Output Process Variable for the primary mA output.
Note
If you configure a display variable as a volume process variable and then change Volume Flow Type, the
display variable is automatically changed to the equivalent process variable. For example, Volume Flow
Rate would be changed to Gas Standard Volume Flow Rate.
Procedure
For each display variable you want to change, assign the process variable you want to use.
Configure device options and preferences
Configuration and Use Manual 59