Filter
Top Products
Effect of the Flow Direction parameter and actual flow direction on flow
totals and inventories
Table 4-9:
Flow Direction setting
Actual flow direction
Forward Zero flow Reverse
Forward Totals increase Totals do not change Totals do not change
Reverse Totals do not change Totals do not change Totals increase
Bidirectional Totals increase Totals do not change Totals decrease
Absolute Value Totals increase Totals do not change Totals increase
Negate Forward Totals do not change Totals do not change Totals increase
Negate Bidirectional Totals decrease Totals do not change Totals increase
4.5 Configure density measurement
The density measurement parameters control how density is measured and reported.
Density measurement (along with mass measurement) is used to determine liquid volume
flow.
The density measurement parameters include:
• Density Measurement Unit
• Slug Flow Parameters
• Density Damping
• Density Cutoff
4.5.1 Configure Density Measurement Unit
Display (standard) OFF-LINE MAINT > OFF-LINE CONFG > UNITS > DENS
Chinese-language
display
Offline Maintain > Configuration > Units > Density
ProLink II ProLink > Configuration > Density > Dens Unit
ProLink III Device Tools > Configuration > Process Measurement > Density
Field Communicator Configure > Manual Setup > Measurements > Density > Density Unit
Overview
Density Measurement Unit specifies the units of measure that will be displayed for density
measurement.
Procedure
Set Density Measurement Unit to the option you want to use.
Configure process measurement
44 Micro Motion
®
Model 1700 Transmitters with Analog Outputs