Filter
Top Products
4.2.2 Configure Volume Flow Measurement Unit for liquid
applications
Display (standard) OFF-LINE MAINT > OFF-LINE CONFG > UNITS > VOL
Chinese-language
display
Offline Maintain > Configuration > Units > Volume Flow Rate
ProLink II ProLink > Configuration > Flow > Vol Flow Unit
ProLink III Device Tools > Configuration > Process Measurement > Flow
Field Communicator Configure > Manual Setup > Measurements > Flow > Volume Flow Unit
Overview
Volume Flow Measurement Unit specifies the unit of measurement that will be displayed for the
volume flow rate. The unit used for the volume total and volume inventory is based on this
unit.
Prerequisites
Before you configure Volume Flow Measurement Unit, be sure that Volume Flow Type is set to
Liquid.
Procedure
Set Volume Flow Measurement Unit to the unit you want to use.
The default setting for Volume Flow Measurement Unit is l/sec (liters per second).
Tip
If the measurement unit you want to use is not available, you can define a special measurement unit.
Options for Volume Flow Measurement Unit for liquid applications
The transmitter provides a standard set of measurement units for Volume Flow Measurement
Unit, plus one user-defined measurement unit. Different communications tools may use
different labels for the units.
Options for Volume Flow Measurement Unit for liquid applicationsTable 4-3:
Unit description
Label
Display (stand-
ard)
Chinese-lan-
guage display
ProLink II ProLink III Field Commu-
nicator
Cubic feet per second CUFT/S ft3/sec ft3/sec ft3/sec Cuft/s
Cubic feet per minute CUF/MN ft3/min ft3/min ft3/min Cuft/min
Cubic feet per hour CUFT/H ft3/hr ft3/hr ft3/hr Cuft/h
Cubic feet per day CUFT/D ft3/day ft3/day ft3/day Cuft/d
Configure process measurement
28 Micro Motion
®
Model 1700 Transmitters with Analog Outputs