Filter
Top Products
4—Setting Up and Basic Operations
80 www.rolandus.com Roland VS-2480 Owner’s Manual
5. Press SCENE again, and then 2 on the keypad to recall Scene 02—AcIntro Dflt. The
display changes to show that this scene uses different V-Tracks than Scene 01.
6. Press ZERO and then PLAY to hear what’s been added to the project’s introduction.
7. Try out the other scenes in “What You Don’t Know.”
To learn about storing scenes, recalling them and more, see “Scenes” on Page 144.
“Don’t Stop”
Your hard drive also contains a second demo project, “Don’t Stop,” by Teddy Riley. To
learn how to load this demo project, see “Loading a Project” on Page 95.
Turning Off the VS-2480
Turning Off the VS-2480
1. Hold down SHIFT, and press STOP•SHUT/EJECT. The following dialog appears:
2. If you wish to turn off or restart the VS-2480, press ENTER/YES. If not, press EXIT/
NO to cancel the operation. If you press ENTER/YES, a dialog like this one appears:
3. If you’ve made changes to the currently loaded project you’d like to preserve, press
ENTER/YES. If you haven’t, press EXIT/NO.
In either case, the VS-2480 takes a few moments to prepare to shut down—and to
save your project if you pressed ENTER/YES in Step 3. When the VS-2480 is ready
to be powered off, the following message appears:
4. If you’d like to restart the VS-2480, hold down SHIFT and press PLAY•RESTART—
the VS-2480 begins its power-up sequence. If you’d like to shut down the
VS-2480, flip its rear-panel POWER switch to its Off position.
It’s important the you don’t simply flip the VS-2480’s POWER switch to turn it off—
always use the procedure below to prevent damage to your data.
If you’d like to restart the VS-2480—perhaps while troubleshooting a problem—use the
procedure below as well.
If you’re shutting down the VS-2480 when a factory demo song—or any other protected
project—is loaded, you won’t be prompted to store the current song.
If you need to move the VS-2480 after shutting it down, wait 30 seconds or so to give its
hard drive a chance to stop spinning in order to avoid damaging it.
The name of the
currently loaded project.
The project’s sample rate and
recording mode (Page 98).
VS2480OMUS.book 80 ページ ２００６年２月７日 火曜日 午後４時１６分