Filter
Top Products
24—MIDI and Synchronization
302 www.rolandus.com Roland VS-2480 Owner’s Manual
Remote Control of the VS-2480 with SysEx Messages
You can control the VS-2480 using SysEx messages in either of two ways.
Create SysEx Messages Manually
You can manually program the SysEx messages in an external MIDI device for
transmission to the VS-2480. This method requires an in-depth understanding of MIDI
programming—see the
VS-2480 Appendices
for details.
Capture and Return SysEx Messages
Every VS-2480 button-press, knob turn, fader move and so on can generate a SysEx
message that you can transmit from the VS-2480’s MIDI OUT/THRU connector. This
data can be captured by an external MIDI recording device and transmitted back to the
VS-2480. When you’re using the VS-2480 with a sequencer—as described later in this
chapter—the sequencer can record
any
actions you perform on the VS-2480, going
beyond even the extensive automation capabilities of the VS-2480’s Automix feature.
When the sequencer plays back, your moves are faithfully reproduced on the VS-2480.
To transmit SysEx data from the VS-2480:
1. Using a MIDI cable, connect the VS-2480’s MIDI OUT/THRU jack to the MIDI IN
jack of the device in which you want to capture the VS-2480’s SysEx data.
1. Navigate to the MIDI parameter screen (Page 299).
2. Set MIDI OUT/THRU to Out.
3. Turn on the SysEx. Tx Sw (“SysEx Transmit Switch”)—this determines whether or
not SysEx data is transmitted from the VS-2480 as you operate its controls.
4. MIXER CONTROL TYPE sets the type of messages generated by the VS-2480’s
controls. Set it to Excl so that the VS-2480 generates SysEx messages.
Every move you make on the VS-2480 produces a SysEx message that’s transmitted
from the MIDI OUT/THRU jack to the external MIDI device.
To receive SysEx Data from an external MIDI device:
1. Using a MIDI cable, connect the VS-2480 MIDI IN jack to the MIDI OUT jack of the
device from which you want to receive SysEx data.
2. Navigate to the MIDI parameter screen (Page 299).
3. Turn on SysEx. Rx Sw so that the VS-2480 responds to received SysEx data.
Changing Scenes via MIDI
You can send the VS-2480 Program Change values on MIDI Channel 16 to recall scenes
in the current project. Program Change Numbers 00-99 recall Scenes 00-99.
You can also store VS-2480 settings in an external MIDI device using the VS-2480’s
SysEx bulk dump capabilities—see Page 304.
You can record the SysEx data on a track in a sequencer you’re synchronizing with the
VS-2480, as discussed later in this chapter.
The VS-2480 can’t switch scenes while its hard disk recorder is playing back. When it
receives a Program Change on MIDI Channel 16 during playback, playback pauses, the
requested scene is recalled, and playback then resumes.
Received Program Changes on MIDI Channel 16 are ignored during recording.
VS2480OMUS.book 302 ページ ２００６年２月７日 火曜日 午後４時１６分