Filter
Top Products
11—Input and Track Channel Tools
Roland VS-2480 Owner’s Manual www.rolandus.com 153
About Aux Send Configuration
In the VS-2480, each Aux bus can accept pre-fader signals from all input and track
channels
or
post-fader signals from the input and track channels—not a mix of both. An
Aux bus can also be linked with its odd/even partner to form a single stereo send. You
can configure an Aux bus on the MASTER EDIT VIEW screen (Page 207) or from the
CH EDIT VIEW screen as described on Page 207.
7. ATT
The ATT (“Attenuation”) parameter allows you to adjust the level of the
signal coming into the channel. If the signal is clipping or sounds distorted,
you can lower the ATT value by as much as -42.0 dB. If the signal is too soft,
you can raise it by up to 6.0 dB.
When you’re working with analog input signals, you won’t usually need to change the
ATT setting if you’ve properly set your input levels (Page 130). The same is true if you’ve
recorded your tracks correctly—as described on Page 58. Even so, the ability to adjust
the level of the signal coming into a channel can be handy if the need arises.
8. DYNAMICS
The DYNAMICS section provides an on/off switch that lets you turn
the channel’s dynamics tools on or off from the VIEW screen, and
graphically shows you the current dynamics settings. The channel’s
dynamics parameters are found on its DYN screen (Page 157).
9. EQ
In the VIEW screen’s EQ section, you can see the channel’s
current EQ settings presented in graphic form, and can turn all
of the channel’s EQ bands on or off with a single switch. Set the
channel’s EQ parameters on its EQ screen (Page 162).
To learn about pre- and post-fader Aux sends, see “Pre-Fader and Post-Fader Sends”
on Page 83. For more about linking Aux busses, see “Stereo Aux Busses” on Page 206.
You can also send channel signals to an Aux bus using the PAN/AUX SEND 1-8
knobs—see “Using the PAN/AUX SEND 1-8 Knobs” on Page 139.
The ATT parameter can be particularly handy when you’re working with a digital input
signal, since its input level is set by the device producing it. You can adjust its input
channel’s ATT value to place the signal at a proper level (Page 58).
When the DYNAMICS on/off switch is selected, press the flashing
ENTER/YES button to jump directly to the DYN screen.
When the EQ on/off switch is selected, press the flashing ENTER/YES button to jump
directly to the EQ screen.
Dynamics on/off
switch
EQ on/off switch
VS2480OMUS.book 153 ページ ２００６年２月７日 火曜日 午後４時１６分