Roland VS-2480 Stereo Equalizer User Manual


 
23—EZ Routing
296 www.rolandus.com Roland VS-2480 Owner’s Manual
Saving and Loading EZ Routing Templates
As you use your VS-2480, you’ll spend lots of time creating routing setups for the
various situations in which you’ll be recording and mixing. You can save a routing
setup—along with a host of other parameters—as an EZ Routing template that you can
use in any project. When you recall a template, all of the routings and parameter values
it contains are instantly restored, saving you lots of setup time. You can save up to 20 EZ
Routing templates.
The Type of Settings a Template Contains
An EZ Routing template remembers everything that pertains to routing and
configuration-related parameters—including input channel, track channel and Aux bus
linking, V-Track selection and the current settings of the hard disk recorder’s TRACK
STATUS buttons.
Saving an EZ Routing Template
1. Set up your VS-2480 as desired.
2. Press EZ ROUTING.
3. If “SAVE” isn’t visible above F6, press PAGE until it is.
4. Press F6 (SAVE)—the EZ ROUTING TEMPLATE SAVE screen appears.
5. Turn the TIME/VALUE dial to select the desired user template memory location.
6. Press F1 (NAME) to name the template you’re saving. See Page 73 to learn about
naming. If you’d don’t want to name the new template, skip this step.
7. When you’re ready to finish saving the template, press F5 (OK), or press F6 (EXIT)
to cancel the operation.
8. Press ENTER/YES to save the template, or EXIT/NO to cancel the operation.
While some of the parameters saved in an EZ Routing template are also stored in
scenes, a scene belongs to a particular project, while an EZ Routing template is always
available.
The VS-2480 ships with seven always-available EZ Routing templates for recording,
bouncing, mixdown and Surround mixing. You can find a list of the connections and
parameters each of these templates installs on Page 397.
VS2480OMUS.book 296 ページ 2006年2月7日 火曜日 午後4時16分