Filter
Top Products
2—Getting Around
46 www.rolandus.com Roland VS-2480 Owner’s Manual
11—Numeric keypad•AUX 1-8, USER
The numeric keypad serves two general purposes:
• You can type the desired number or numbers on it when storing and recalling
locators, scenes and markers, or when entering values when NUMERICS is lit.
• When KNOB/FDR ASSIGN•AUX SEND 1-8 is flashing, you can assign the PAN/
AUX SEND 1-8 knobs to the job of sending signals from the individual channel
strips to one of the eight Aux busses (Page 141) by pressing the desired 1-8 button,
or to some other job by pressing 9•USER (also Page 141).
The Rear Panel of the VS-2480
1—POWER Switch
Use the POWER switch to turn the VS-2480
on and off.
2—AC IN Jack
Connect one end of the supplied AC power
cord to a grounded AC outlet, and the other
end to the AC IN jack.
3—Cooling Fan Exhaust Vent
The VS-2480 contains a cooling fan that prevents it from overheating. The fan expels hot
air through this exhaust vent.
Bus
Every set of ten items on the numeric keypad—banks, locators, scenes and so on—is
numbered from 0 to 9.
Don’t simply flip the POWER switch
when you want to shut down the
VS-2480—if you do this, data loss may
occur. Make sure to use the proper
shutdown procedure, described on
Page 80.
Use only the supplied AC power cord to prevent damage to your VS-2480.
Be sure never to block the cooling fan exhaust vent. If hot air from the VS-2480 chassis
isn’t allowed to escape through this vent, the VS-2480 may overheat and be damaged.
POWER
ON
AC IN
1
23
VS2480OMUS.book 46 ページ ２００６年２月７日 火曜日 午後４時１６分