Filter
Top Products
10—Using the Digital Mixer
146 www.rolandus.com Roland VS-2480 Owner’s Manual
3. Press
or
or turn the TIME/VALUE dial to select the desired scene. You can:
• Press F1 (NAME) to rename (Page 73) the selected scene.
• Press F2 (CLEAR) to delete the selected scene.
• Press F3 (STORE) to store your current settings as the selected scene.
• Press F4 (RECALL) to recall the selected scene.
• Press F5 (Ch Sel) to protect channels when scenes are recalled—see below.
4. Press F6 (EXIT) when you’re done to confirm your changes.
Protecting a Channel’s Settings When a Scene is Recalled
1. Press UTILITY.
2. Press PAGE repeatedly until “SCENE” appears over F1.
3. Press F1 (SCENE).
4. Press F5 (CH Sel). The channel-selection box appears.
Each channel is represented by a box. When the box is black, its settings will be
changed when a scene is recalled. When it’s white, they won’t.
5. Press
,
,
and/or
to select a channel you want to protect. (In the above
illustration, Input Channel 1 is selected, as shown by the outline around its box.)
6. Turn the TIME/VALUE dial so the channel’s box turns white to show it’s protected.
7. Repeat Steps 5 and 6 for any channels you want to protect/ignore.
8. Press F6 (EXIT) when you’re done.
Scenes in Safe Mode
Scenes are so fast and easy to recall that it’s possible to recall the wrong one, especially
since you normally recall a scene by its number, not its name. The VS-2480 provides a
Safe mode that allows you to work with scenes in a SCENE window that shows each
scene’s number
and
name. You can also store and clear scenes in Safe mode. While this
is a slower way to work, it provides greater certainty that you’ve got the right scene.
The UTILITY menu’s LOCATOR/SCENE TYPE parameter turns Safe mode on or off—
see Page 364. Its default value is Quick. To turn on Safe mode, select Safe.
Recalling a Scene in Safe Mode
1. Press SCENE—the SCENE window opens.
2. Turn the TIME/VALUE dial to scroll through the list
until the desired scene is visible.
3. Enter the scene’s two-digit number on the keypad—
an arrow appears to the left of the scene in the list,
and “Load Scene?” appears in the window.
You can store a new scene by selecting a blank scene location in the list and pressing F3
(STORE).
VS2480OMUS.book 146 ページ ２００６年２月７日 火曜日 午後４時１６分