Filter
Top Products
20—Region Editing Operations
Roland VS-2480 Owner’s Manual www.rolandus.com 267
AllVTr
Turn AllVTr on if you want to remove the chunk of time from all of the V-Tracks
belonging to a selected track.
ERASE
Use: Mouse, TRACK EDIT buttons, TRACK menu
Erase removes a specified region from a selected track, leaving all of its
other audio where it is.
Why You’d Use Region ERASE
Region ERASE is a really good way to get rid of unwanted audio—wrong notes, noises,
throat-clearing, unwanted chatter and so on—on a track without affecting the rest of its
audio.
Edit Points
•
IN
—sets the beginning of the audio segment you’re erasing.
•
OUT
—sets the end of the audio segment you’re erasing.
AllVTr
Turn AllVTr on if you want to remove the audio from all of the V-Tracks belonging to a
selected track. You’ll want to do this if each V-Track contains a different performance
attempt, and they all contain the same mistake.
COMP/EXP.
Use: Mouse, TRACK EDIT buttons, TRACK menu
The region COMP/EXP. (“Compression/Expansion”) operation allows
you to time-stretch or time-shrink a region, with or without changing
the region’s pitch.
Thanks to the VS-2480’s non-destructive editing, anything you erase is still on your
hard drive if you want it back, until you optimize the project. Use Undo to retrieve it, or
create a new phrase from its original take (see Page 259).
Make sure there’s no audio within 0.5 seconds before the IN point and 0.5 seconds after
the OUT point to ensure a smooth transition.
Time compression and expansion cannot be used on tracks recorded using the CDR
recording mode.
Since the COMP/EXP. operation makes a new copy of any region it’s processing, it can
be performed only when there’s sufficient free space on your hard drive.
TRACK menu
F5 (ERASE)
IN
OUT
Before region ERASE
After region ERASE
IN
OUT
TRACK menu
F1 (CmpExp)
VS2480OMUS.book 267 ページ ２００６年２月７日 火曜日 午後４時１６分