Filter
Top Products
7—Project and Drive Operations
Roland VS-2480 Owner’s Manual www.rolandus.com 105
1. Load the project you want to use as the basis for the final project.
2. Press PROJECT.
3. Select the project you want to add to the end of the loaded project.
4. If “COMBIN” isn’t visible above F4, press PAGE until it is.
5. Press F4 (COMBIN)—the VS-2480 asks:
6. Press ENTER/YES to proceed with the combining of the two projects, or press
EXIT/NO to cancel the operation.
7. If you pressed ENTER/YES, the VS-2480 asks again if you’re really sure:
8. Press ENTER/YES to proceed, or EXIT/NO to cancel.
The VS-2480 asks if you want to save any changes you’ve made to the currently
loaded project before proceeding.
9. Press ENTER/YES to store the current project’s changes, or press EXIT/NO to skip
directly to the combining of the two projects.
BACKUP
We strongly recommend that you back up your projects regularly. When you back up a
project, you make a copy of it on a CD-R or CD-RW, and store the backup in a safe,
separate place. Though your VS-2480 is an extremely reliable device, unexpected
events—including power outages and worse—
can
occur during its operation. The only
way to guarantee that your work remains safe is to back it up.
You can re-load a project backup at any time by performing a RECOVER operation—
see Page 107.
When you connect a Roland-approved CD-R/RW drive to your VS-2480, you can back
up your VS-2480 projects on reliable CD-R and/or CD-RW disks. We recommend
backing up on CD-R or CD-RW disks since many VS-2480 projects can fit on a single
disk, and the disks themselves are inexpensive. You can also back up a project on one or
more Zip disks.
A Roland VS-CDRII, CD-RACK or a Zip drive must be purchased separately.
To learn how to connect a CD-R/RW drive or a Zip drive to the VS-2480, see Page 381.
PROJECT menu
F4 (COMBIN)
VS2480OMUS.book 105 ページ ２００６年２月７日 火曜日 午後４時１６分