Filter
Top Products
25—Surround
Roland VS-2480 Owner’s Manual www.rolandus.com 321
Turning on Surround Mode
To create a Surround mix, you must be in Surround mode.
1. Press UTILITY.
2. If “Surrnd” isn’t visible above F3, press PAGE until it is.
3. Press F3 (Surrnd) to view the SURROUND screen.
4. Set SURROUND MIX MODE to the desired Surround format.
5. Turn the SURROUND MIX Sw parameter on. The VS-2480 reminds you that it’s
about to re-configure your Aux busses, and asks if you’re sure you want to switch to
Surround mode.
6. Press ENTER/YES to proceed, or EXIT/NO to cancel the activation of Surround
mode.
If you pressed ENTER/YES in Step 6, the VS-2480 reminds you that your current
channel panning settings will also be affected by the switch to Surround mode.
7. Press ENTER/YES to proceed, or EXIT/NO to cancel the change into Surround
mode.
When you switch to Surround mode, connections are broken between any Aux busses
required by the selected Surround format and the VS-2480’s internal effects in order to
prevent confusion. You can re-route the Aux busses to the effects if you wish (Page 294).
This message also appears if you change Surround formats when Surround mode is
already turned on.
If you’ve got mixer settings you’d like to preserve, press EXIT/NO, save them as a scene
and then activate Surround mode.
VS2480OMUS.book 321 ページ ２００６年２月７日 火曜日 午後４時１６分