Filter
Top Products
23—EZ Routing
294 www.rolandus.com Roland VS-2480 Owner’s Manual
On this screen, you can also configure the track direct outputs so that they’re pre-fader
or post fader (Page 290), and adjust the overall hard disk recorder track recording level
using the REC ATT parameter (Page 201).
Making Connections on the EZ ROUTING OUTPUT ASSIGN Screen
1. Use
or
to select the desired pair of outputs.
2. Turn the TIME/VALUE dial to create the desired connection.
Output routing is described in detail in Chapter 22. In addition, on Page 75, you’ll find a
detailed set of steps for setting up digital monitoring through a pair of Roland DS-90A
or DS -50A Digital Reference Monitors.
The EZ ROUTING LOOP EFFECT ASSIGN Screen
On the EZ ROUTING LOOP EFFECT ASSIGN screen, you can select the Aux or Direct
bus that carries signals to each of the VS-2480’s internal effect processors. You can also
see a symbol for each processor’s currently selected effect patch.
Making Connections on the LOOP EFFECT ASSIGN Screen
1. Use
or
to select the desired internal effect processor.
2. Turn the TIME/VALUE dial to select the desired Aux bus or Direct bus.
The routing of Aux busses and Direct busses to the internal effects is discussed in detail
on Page 210.
For the purposes of routing, busses are treated as odd/even pairs that can include two
mono busses or one stereo bus. Tracks are also routed in pairs. Outputs are divided into
odd/even, left/right pairs as well. These pairs cannot be altered.
If you cursor all the way to the left, you’ll select the MONITOR bus assignment
junction. Turn the TIME/VALUE dial to select the pair of busses—or stereo bus—you’d
like to send into the stereo MONITOR bus.
If an Aux bus is linked to its odd/even partner (Page 206), “L” and “R” are attached to
the end of their names.
Linked Aux busses are routed to an internal effect as a single stereo source.
Effect
processors
Busses
If there’s no optional
VS8F-2 effect expansion
board installed for an effect
processor, “No FX Board”
appears instead of an effect
patch symbol.
VS2480OMUS.book 294 ページ ２００６年２月７日 火曜日 午後４時１６分