Filter
Top Products
13—Operating the Hard Disk Recorder
186 www.rolandus.com Roland VS-2480 Owner’s Manual
Basic Locator Operations
The following operations take place when the LOCATOR indicator is
lit to signify you’re in Locator mode.
Storing a Locator
1. Press LOCATOR•BANK if it’s not already lit.
Each locator bank contains 10 memory slots, numbered from 0-9, in which a locator
can be stored. These memory slots correspond to the 0-9 buttons on the numeric
keypad. When a locator’s been stored in a slot, its button lights on the keypad.
2. Press any 0-9 button on the keypad to store the locator in the corresponding
memory slot. If you’d like to store the locator in a different locator bank, see
“Changing Locator Banks” and press the desired button in the selected bank.
3. If a memory slot already contains a locator, and you want to store a new locator
there, you’ll have to first clear the older locator. See “Clearing a Locator” below.
Recalling a Locator
1. Press LOCATOR if it’s not already lit.
2. If the currently selected locator bank contains the locator you want, press the
locator’s lit button on the keypad. To recall a locator from another bank, follow the
instructions in “Changing Locator Banks” and press its button in the selected bank.
Changing Locator Banks
1. Press LOCATOR if it’s not already lit. If any locators are stored in the currently
selected locator bank, their buttons light on the numeric keypad.
2. While holding down SHIFT, press LOCATOR•BANK. The button for the currently
selected bank lights solidly, and the other keypad buttons flash.
3. Press 0-9 to select the desired locator bank—if locators are stored there, their
numbers light on the keypad.
Clearing a Locator
1. Press LOCATOR if it’s not already lit. If you’d like to clear a locator from a different
bank, see the instructions in “Changing Locator Banks” first.
2. While holding down CLEAR, press the desired locator’s button on the keypad. The
locator is cleared from that memory slot, and the button’s light turns off.
Other Locator Operations
Editing Locators
You can edit locators on the UTILITY menu’s LOCATE screen. You can name them,
clear them, create them, change their positions and jump to them from this screen.
1. Press UTILITY.
2. Press PAGE repeatedly until “LOCATE” appears over F5.
3. Press F5 (LOCATE).
You can use the Locator feature’s Safe mode to perform locator
operations more carefully from list in a LOCATOR window. See Page 187.
You can store locator’s while a project’s playing or when it’s stopped.
32
0
/-
56
1
4
987
LOCATOR
PRE
PREV
IOUS
IOUS
NE
NEXT
SCENE
BANK AUX 7 AUX 8 USER
AUX 4 AUX 5 AUX 6
AUX 1 AUX 2 AUX 3
BANK
MA
RKER
RKER
LOCATOR / MARKER / SCENE
VS2480OMUS.book 186 ページ ２００６年２月７日 火曜日 午後４時１６分