Filter
Top Products
Configuration and Use Manual 53
Optional Configuration Using the FillerFiller ConfigurationUsing the Transmitter
Chapter 7
Configuring the Filling and Dosing Application
7.1 About this chapter
This chapter explains how to configure the filling and dosing application on the Model 1500
transmitter. For information on using the filling and dosing application, see Chapter 8.
7.2 User interface requirements
ProLink II v2.3 or later is required to configure the filling and dosing application.
Alternatively, configuration can be performed via a customer-written program using the Modbus
interface to the Model 1500 transmitter and the filling and dosing application. Micro Motion has
published the Modbus interface in the following manuals:
• Using Modbus Protocol with Micro Motion Transmitters, November 2004, P/N 3600219,
Rev. C (manual plus map)
• Modbus Mapping Assignments for Micro Motion Transmitters, October 2004, P/N 20001741,
Rev. B (map only)
Both of these manuals are available on the Micro Motion web site.
7.3 About the filling and dosing application
The filling and dosing application is used to begin flow, then end flow automatically when the target
amount of process fluid has flowed through the sensor. During a fill, flow may be paused and
resumed. A fill may also be ended before the target is reached.
CAUTION
Changing configuration can affect transmitter operation, including filling.
Changes made to filling configuration while a fill is running do not take effect until
the fill is ended. Changes made to other configuration parameters may affect filling.
To ensure correct filling, do not make any configuration changes while a fill is in
progress.