Filter
Top Products
Configuration and Use Manual 117
Default Values and Ranges
Measurement Performance DefaultsTroubleshootingCompensation Measurement Performance DefaultsTroubleshootingCompensation Measurement Performance DefaultsTroubleshootingCompensation Measurement Performance DefaultsTroubleshootingCompensation
Event 2 Variable Density
Type Low alarm
Setpoint 0.0
Setpoint units g/cm
3
Update Rate Update rate Special Normal or
Special
Analog output Primary variable Mass flow
LRV –200.00000 g/s
URV 200.00000 g/s
AO cutoff 0.00000 g/s
AO added damping 0.00000 sec
LSL –200 g/s Read-only
USL 200 g/s Read-only
MinSpan 0.3 g/s Read-only
Fault action Downscale
AO fault level – downscale 2.0 mA 1.0–3.6 mA
AO fault level – upscale 22 mA 21.0–24.0 mA
Last measured value timeout 0.00 sec
LRV Mass flow –200.000 g/s
Volume flow –0.200 l/s
URV Mass flow 200.000 g/s
Volume flow 0.200 l/s
Fill Flow source Mass flow rate
Enable Filling Option Enabled
Count Up Enabled
Enable AOC Enabled
Enable Purge Disabled
Fill Type One Stage Discrete
Configure By % Target
Fill Target 0.00000 g
Max Fill Time 0.00000 sec
Purge Mode Manual
Purge Delay 2.00000 sec
Purge Time 1.00000 sec
AOC Algorithm Underfill
AOC Window Length 10
Fixed Overshoot Comp 0.00000
Valve control –
Two-stage
discrete fill
Open Primary 0.00% of target 0.00–100 %
Open Secondary 0.00% of target 0.00–100 %
Close Primary 100.00% of target 0.00–100 %
Close Secondary 100.00% of target 0.00–100 %
Table A-1 Transmitter default values and ranges continued
Type Setting Default Range Comments