Filter
Top Products
22 Micro Motion
®
Model 1500 Transmitters with the Filling and Dosing Application
Required Transmitter Configuration
4.4.3 Density units
The default density measurement unit is
g/cm3. See Table 4-3 for a complete list of density
measurement units.
4.4.4 Temperature units
The default temperature measurement unit is
degC. See Table 4-6 for a complete list of temperature
measurement units.
4.4.5 Pressure units
Configuring the pressure unit is required only if pressure compensation will be implemented. See
Section 9.2.
4.5 Configuring the mA output
The mA output can be used either to report the mass flow or volume flow process variable or to
control a valve for the filling and dosing application.
Configuring the mA output for valve control is discussed in Section 7.4.
Note: If the mA output is configured for valve control, it cannot be used to report alarm status, and
the mA output will never go to fault levels.
Table 4-5 Density measurement units
ProLink II label Unit description
SGU Specific gravity unit (not temperature corrected)
g/cm3 Grams per cubic centimeter
g/l Grams per liter
g/ml Grams per milliliter
kg/l Kilograms per liter
kg/m3 Kilograms per cubic meter
lbs/Usgal Pounds per U.S. gallon
lbs/ft3 Pounds per cubic foot
lbs/in3 Pounds per cubic inch
degAPI API gravity
sT/yd3 Short ton per cubic yard
Table 4-6 Temperature measurement units
ProLink II label Unit description
degC Degrees Celsius
degF Degrees Fahrenheit
degR Degrees Rankine
degK Degrees Kelvin