Filter
Top Products
Configuration and Use Manual 35
Optional Configuration Using the FillerFiller ConfigurationUsing the Transmitter
Chapter 6
Optional Transmitter Configuration
6.1 Overview
This chapter describes transmitter configuration parameters that may or may not be used, depending
on your application requirements. For required transmitter configuration, see Chapter 4.
The following configuration parameters and options are described in this chapter:
• Special measurement units (see Section 6.4)
• Cutoffs (see Section 6.5)
• Damping (see Section 6.6)
• Update rate (see Section 6.7)
• Flow direction (see Section 6.8)
• Events (see Section 6.9)
• Slug flow (see Section 6.10)
• Fault handling (see Section 6.11)
• Digital communications settings (see Section 6.12)
• Variable mapping (see Section 6.13)
• Device settings (see Section 6.14)
• Sensor parameters (see Section 6.15)
6.2 Default values
Default values and ranges for the most commonly used parameters are provided in Appendix A.
6.3 Parameter location within ProLink II
For information on parameter location within the ProLink II interface, see Appendix C.
6.4 Creating special measurement units
If you need to use a non-standard unit of measure, you can create one special measurement unit for
mass flow and one special measurement unit for volume flow.