Filter
Top Products
PAN/ROUTE screen
— Reference Guide 53
● Setting or defeating pairing for
channels/buses
[Procedure]
1. To pair channels or buses, move the cur-
sor in the Pair CH page/Pair Bus page to a
button that is displayed as “MONO x 2,”
and press the [ENTER] key.
The PAIRING popup window will appear,
allowing you to specify how the pairing will
occur.
Tip!
Another way to pair channels is to simulta-
neously press adjacent odd-numbered
→
even-numbered [SEL] keys. In this case, the
above window will appear when you press
the two [SEL] keys simultaneously.
2. Move the cursor to either the “INPUT 1 →
2,” “INPUT 2 → 1,” or “RESET BOTH” but-
ton, and press the [ENTER] key.
You can select one of the following three pair-
ing methods.
● INPUT x → y (x=odd number, y=even num-
ber)
The parameters of the odd-numbered channel/
bus (except for attenuator and pan) will be cop-
ied to the even-numbered channel.
● INPUT y → x (x=odd number, y=even num-
ber)
The parameters of the even-numbered channel/
bus (except for attenuator and pan) will be cop-
ied to the odd-numbered channel.
● RESET BOTH
The parameters of both odd and even-num-
bered channels/buses will be reset to their
default values.
When you execute pairing, the button display
will change to “STEREO.” When you use the
[SEL] keys to select a paired channel, the other
[SEL] key will blink.
3. To defeat pairing, move the cursor to a
button displayed as “STEREO” and press
the [ENTER] key.
A popup window will appear, asking you to
confirm that you wish to defeat pairing.
Tip!
You can also defeat channel pairing by press-
ing the two [SEL] keys simultaneously.
4. Move the cursor to the OK button and
press the [ENTER] key.