MIDI screen
42 — Reference Guide
When using MMC, you must match the
device ID of the AW4416 and the external
MIDI device. For details on setting the device
ID, refer to MMC DEV.
6
.
D SYNC AVE. (sync average)
When the AW4416 is used as an MTC slave,
this parameter specifies the precision with
which MTC will be received.
Normally you will use this with the “OFF” but-
ton selected. However if synchronization is
unreliable, try the 1 or 2 setting.
E SYNC OFFSET
When the AW4416 is used as an MTC slave,
this parameter specifies how the absolute time
of the AW4416 will be shifted relative to the
time code (MTC) received from the external
device. You can specify a range of “–
24:00:00:00.00”–”+24:00:00:00.00”.
Tip!
The offset value you specify here does not
affect the MTC that is transmitted from the
MTC OUT connector of the AW4416. If you
want the MTC transmitted from the MTC
OUT connector to be shifted relative to the
absolute time of the AW4416, you must
adjust the Time Code Top (SONG screen Set-
ting page).
F MMC DEV. (MIDI Machine Control
device)
When using MMC for remote control, specify a
device ID of 1–127 to distinguish each device.
Received
time code
Received
time code
Received
time code
00:00:00:00.00 00:00:05:00.00
Sync offset= 00:00:00:00.00
Sync offset= +00:30:00:00.00
00:3030:00:00.00 00:35:00:00.00
Sync offset= –01:00:00:00.00
23:00:00:00.00 23:05:00:00.00
Song
Song
Song