Yamaha AW4416 Stereo System User Manual


 
Chapter17—Mastering
— Operation Guide 259
Writing the master
Here’s how to use the mastering function to write the stereo track data to CD-R/
RW media.
1. Press the [MASTERING] key.
The MASTERING screen will appear in the display.
2. Hold down the [SHIFT] key and press the [F2] key (CD UNLOAD).
The tray of the CD-RW drive will open.
3. Place a CD-R/RW disc on the tray. Then hold down [SHIFT] and press the
[F1] key (CD LOAD).
The tray will close.
4. Use the [DATA/JOG] dial to select the SCSI ID number of the AW4416’s
internal CD-RW drive, and press the [ENTER] key.
In the MASTERING screen, you can access all stereo tracks (44.1 kHz sam-
pling frequency) saved on the internal hard disk. Thus, it is not necessary that
the stereo track be part of the current song.
However, the mastering function cannot be used if the current song has a sam-
pling frequency of 48 kHz. In this case, you must load a 44.1 kHz song before
you begin the mastering procedure.