Yamaha AW4416 Stereo System User Manual


 
PAN/ROUTE screen
50 — Reference Guide
[Screen functions]
A Channel
This indicates the channel for which pan/rout-
ing is being set.
B Bus assign buttons 1–8
These buttons assign the signal of each channel
to buses 1–8.
C ST (stereo bus assign) buttons
These buttons assign the signal of each channel
to the stereo bus.
D PAN knobs
These knobs pan the signal between L/R of the
stereo bus and between odd-numbered and
even-numbered buses. Use the [DATA/JOG]
dial to operate the knobs. Pressing the [ENTER]
key will set the knob to the CENTER position.
The ST OUT knobs in the Pan 17–24 page
adjust the output channel balance.
E MODE
Use the following three buttons to select how
the PAN knob will function for paired channels.
INDIVIDUAL button
The pan of each channel will operate indepen-
dently. (Default setting)
GANG button
The pan of paired channels will be linked while
preserving the existing spatial relationship.
INVERTED GANG button
The pan of paired channels will be linked
inversely.
On the AW4416, the pan of a channel can be
adjusted in the following two ways.
(1). Use the [SEL] keys to select the desired
channel, and rotate the [PAN] control.
If AUTO PAN DISPLAY is turned “ON” in
the UTILITY screen Prefer.1 page ([UTIL-
ITY] key
[F2] key), operating the [PAN]
control will automatically switch the dis-
play to the PAN/ROUTE screen even if a
screen other than the PAN/ROUTE
screen had been displayed.
(2). In the PAN 1–16/PAN 17–24/PAN MONI
pages, move the cursor to the PAN knob
of the desired channel and rotate the
[DATA/JOG] dial.
In the PAN 1–16/PAN 17–24/PAN MONI
pages, the channel can be specified freely,
regardless of the state of the [SEL] keys. For
this reason, there may be cases in which the
channel whose pan is adjusted by the [PAN]
control is different than the channel whose
pan is adjusted by the [DATA/JOG] dial.
Pan MONI
1
2
3
4
5