Filter
Top Products
EDIT PROGRAM - SINGLE
CD3000XL OperatorÕs Manual Page 65
NAMING PROGRAMS - COPYING AND RENAMING
If you have already recorded your own samples, then this procedure should be familiar as it
follows the same conventions.
To copy or rename a program, press the NAME key. The following prompt will appear:
Use the CURSOR keys to move around the name field, rotate the DATA knob to enter a name
of up to 12 characters (only caps). Use the -/< key and +/> key to enter a backspace and a
space respectively.
When you have entered your name, press ENT and you will get this prompt:
Pressing will copy the original program - use this to create a new program.
If the program name is an existing one, the boxed area in the bottom right of the screen will
show:
You will receive the following prompt:
You must enter a unique new name.
Pressing will simply rename the currently selected program with the name just entered.
If the name exists, you will be prompted as above and you must re-enter a unique name.
Pressing will exit the naming process altogether with no action taking place. Should you
press this by mistake, you will see that the boxed area in the lower right of the screen still
retains the new name you entered so press NAME immediately followed by ENT and make
your choice again.