Filter
Top Products
FLASHROM
CD3000XL OperatorÕs Manual Page 289
COPYING A FLASHROM SAMPLE TO RAM
If you really do need to edit a sample in the FlashROM, the original sample will need to be
loaded into RAM. This is done in the LOAD mode.
On CD3000XL, go to LOAD and select the volume the sample is in (if you just loaded from it,
this should be the selected volume) and select CURSOR ITEM ONLY:
Move the cursor to the sample you wish to load. Proceeding with CLEAR or GO will then give
this second level of prompting:
Pressing F7 - COPY - will load the selected sample into RAM where it may be edited as normal
with none of the restrictions described on the previous page. Pressing F8 - LOAD - will ‘load’
the sample as a FlashROM sample (i.e. the sample will be played directly from ROM and you will
not be able to perform certain sample editing functions).
NOTE: You will only receive this second level of prompting if the selected single item is a
sample. If you select to load a single program or multi or effects file, the COPY TO RAM? prompt
will not appear.
Alternatively, if you know where the original sample is on disk, you may prefer just to load it
straight from disk, bypassing the procedure described above.