Filter
Top Products
APPENDIX 3
Page 298 CD3000XL OperatorÕs Manual
IMPORTANT NOTES ABOUT INSTALLING THE FMX008
When you install the FMX008 board, please note that the following problems could be had.
• ALWAYS disconnect the sampler’s mains lead from the mains outlet when opening the
sampler’s casework.
• Unless you have disconnected the sampler’s mains lead from the mains outlet, you run the
risk of an electric shock which could be fatal. You also run the risk of damaging the
FMX008, the sampler or any other equipment that may be connected to the sampler.
• Depending on your environment, your body could have a high static electricity charge
which, when you handle the FMX008 board, could destroy the memory chips on it and/or
cause damage to the sampler’s circuitry. To minimise static electricity, avoid carpeted areas
and low humidity areas.
• If the board is inserted incorrectly and/or damaged, this could cause long term (and
expensive) damage to the FMX008 board and/or your sampler.
• Akai Electric Co. cannot be held responsible for any damage to the FMX008 board, the
sampler and/or any peripheral equipment (disk drives, mixers, amplifiers, recording
equipment, etc.) that may be damaged or for any loss of earnings, income or damage to
your personal or professional reputation, employment opportunities or for any physical
harm that may come to you as a result of incorrect installation of the FMX008.
Installation of the board is fairly straightforward as long as you proceed with caution and take
care and use common sense.
** IMPORTANT NOTE **
Consult your AKAI Professional dealer on installation of any options
(including memory) to the sampler. Self-servicing may cause malfunction of
components or the instrument itself. Akai does not guarantee against the
unit’s malfunction, damage or any loss caused by self-servicing or improper
operation.