Filter
Top Products
GLOBAL
Page 266 CD3000XL OperatorÕs Manual
- This will cause the take to play back upon receipt of a suitable
MIDI note but with a delay offset set in the delay: field described below. If
is pressed, however, playback is immediate in the PLAY page.
- This will cause the take to playback when it receives a MIDI
SONG START command after is pressed.
NOTE: In all the above selections, the key must be pressed before a take is played.
This sets the delay offset used for triggering a takes playback when
is selected in the field described above.
This allows you to set which MIDI note will cause the take to playback when
or is selected.
This allows you to set the MIDI channel for the take. In this way, you can set a
specific MIDI channel for the MIDI triggering of takes.
This field allows you to set the playback level of the take.
This allows you to set the pan position of a mono recording or the left/right
balance of a stereo recording.
This sets the level of the signal that will be sent to the assignable individual
outputs.
This sets the destination of the take. The default is OFF but you may set these
to any outputs you want. The level at which they will appear at the individual
outputs or the effects is set in the field.
The soft keys on this page are:
This takes you to the DD TAKES view page
This takes you the SONG mode where you may compile takes for sequential
playback or MIDI triggering
Shows the currently active page
This takes you to the take editing display
Takes you back to the RECORD SET-UP page
Takes you directly to the record page for recording new takes
Takes you to the BACK-UP SAVE page where you may archive takes to DAT
via the digital audio interface.
This primes the take for immediate playback from within this page