Filter
Top Products
APPENDIX 3
CD3000XL OperatorÕs Manual Page 297
INSTALLING THE FLASHROM
There are two slots into which the FlashROM can be installed. If you are installing only one
board, it has to be inserted into the first slot ‘A’ (P20). Of course, when you install another, then
it is inserted into the second slot ‘B’.
There is a jumper on the board which has to be set according to the position of slot inserted as
follows:
AB
Set the jumper to ‘A’ side (factory setting) when inserted to the first slot and set it to ‘B’ side
when inserted to the second slot.
NOTE: When the second FlashROM is later installed, use the ARRANGE function to format
the second FlashROM without damaging the data in the first FlashROM.
To install the board, first, DISCONNECT THE MAINS. Switching the sampler off is not enough
and you risk an electric shock if the mains lead is not disconnected from the mains outlet.
Remove the top panel by unscrewing the four top screws and the small screw at the rear of the
panel. Keep the screws safe. Remove the top panel. You will see the slots where the
FlashROM is to be inserted.
Memory chips are very sensitive to static electricity and can be destroyed if they get a burst of it.
To discharge any static in your body, touch the casework.
Now take the board BEING EXTREMELY CAREFUL NOT TO TOUCH ANY COMPONENTS ON
THE BOARD and insert it into one of the slots. There is only one way it can be inserted. DO
NOT FORCE THE BOARD INTO THE SLOT AS YOU MAY DAMAGE THE DELICATE PINS.
Once the board is inserted, attach it securely it to the small bracket on the casework using the
screw provided.
Now replace the top panel, ensuring that the four top screws and rear panel screw are securely
fastened.
Now power up the sampler. Once the boot up is complete, you will see the message:
This will confirm that the FlashROM board has been ‘seen’ by the CD3000XL. If two FMX008
boards are installed, the message will tell you “8MW fitted”.