Filter
Top Products
EFFECTS EDIT
CD3000XL OperatorÕs Manual Page 205
Another way to picture the is as follows:
00
MOD/ECHO > REVREV > MOD/ECHO
-50 +50
At values of +01 to +50, more of the mod/echo section is fed to the reverb and setting of -01 to
-50, more of the reverb is fed into the mod/echo section.
As you can see, the offers a great deal of flexibility in the way the effects chain
is laid out with just one simple control. Normally, you will probably use a positive setting (i.e.
flange followed by reverb) and +25 is a good setting for most occasions but, to change this
direction (to flange the reverb, for example), simply set a negative value.
NOTE: Of course, the PATH CONTROL & OUTPUTS screen only applies to the multi-effects
channels FX1 and FX2.
When editing RV3 or RV4, the OUTPUT screen looks like this:
You only have access to the level and pan/balance of the reverb, of course.