Filter
Top Products
SINGLE MODE
Page 28 CD3000XL OperatorÕs Manual
This will execute the currently selected setup and will load marked programs
and their samples and then load any changes and edits to those samples you
might have saved.
NOTE: For a setup to load any edits you may have made top samples or programs, it is
necessary to save these to the floppy in the DISK mode.
MARKING FILES
Pressing will give you a screen display such as:
The primary function of this page is to mark files. Marking a file will allow you to selectively
control which programs from a CD-ROM volume will be loaded when you execute a setup. For
example, in the above screen, if you only wish to load GRND PNO 1, 8VA PIANO and SLOW
PIANO from a setup, move the cursor to the first file, GRND PIANO 1 and press . Now
move the cursor down to 8VA PIANO and press again and repeat the process for SLOW
PIANO. You would have the following screen display:
An asterisk is shown to indicate the marked files. When you press the key in the main
setup page, only those files marked will be loaded. Alternatively, if a MIDI program change
number has been set in the MIDI select: field, when the CD3000XL receives that program
change command, the files marked in this page will be loaded along with their samples and any
changes you may have made to them.
To unmark a single file, simply move the cursor to the appropriate file and press again. To
unmark all files, press the key (F6). You will receive this prompt:
You should answer accordingly by pressing F7 or F8.