Filter
Top Products
Digitizers Command Reference 79Chapter 3
SAMPle
The SAMPle command subsystem sets the number of samples to be taken
for each trigger. It also sets the number of samples to be taken prior to the
trigger and the source of the sample signal and its slope. When the sample
source is TIMer, you can set the sample interval.
Subsystem Syntax SAMPle
:COUNt <count> | MIN | MAX
:COUNt? [MIN | MAX]
[:IMMediate]
:PRETrigger:COUNt <count> | MIN | MAX
:PRETrigger:COUNt? [MIN | MAX]
:SLOPe POS | 1 | NEG | 0
:SLOPe?
:SOURce HOLD | TIMer | TTLT0-7 | EXT
:SOURce?
:TIMer <interval> | MIN | MAX
:TIMer? [MIN | MAX]
SAMPle:COUNt
SAMPle:COUNt <count> | MIN | MAX sets the number of total samples which
includes the pre-trigger and post-trigger samples. The number of samples
set is common to all channels. You cannot have two or more channels with
different sample settings.