Filter
Top Products
Using the Digitizers 41Chapter 2
The trigger source from the slave can be set with TRIG:SOURce2 IMM |
INT1-4 | EXT | TTLT<n>.
SLAVe0 sets the TTLT0 line as if it were SAMP:SOUR TTLT0 and sets the
TTLT1 line as if it were TRIG:SOUR1 TTLT1. However, SAMP:SOUR? or
TRIG:SOUR? will not return these settings. These lines are dedicated for
synchronization between the modules in the master-slave mode. You
should not use these lines for any other purpose with the OUTPut, SAMPle
or TRIGger commands.
MODE SLAVe Sample Signal
SLAVe0 TTLT0
SLAVe2 TTLT2
SLAVe4 TTLT4
SLAVe6 TTLT6