Filter
Top Products
48 Digitizers Command Reference Chapter 3
ABORt
This command aborts a measurement in progress or stops a measurement
being made continuously. The command is ignored without error if a
measurement is not in progress. This command also aborts a calibration in
progress and will set the CAL:STATe to OFF.
Subsystem Syntax ABORt
Comments Determining Readings Taken Before ABORt: Use DATA:COUNt? to
determine how many readings were taken before ABORt was received.
ABORt Settings: ABORt does not affect any instrument settings and is
executable when initiated. ABORt is not a coupled command
Reset (*RST) Condition: None