Filter
Top Products
104 Digitizers Command Reference Chapter 3
TRIGger
The TRIGger command subsystem controls the behavior of the trigger
system.
Subsystem Syntax TRIGger
[:IMMediate]
:LEVel <channel> <level> | MIN | MAX
:LEVel <channel>?
:MODE NORMal | MASTer0,2,4,6 | SLAVe0,2,4,6
:MODE?
:SLOPe[<n>] POS | 1 | NEG | 0
:SLOPe[<n>]?
:SOURce[<n>] OFF | BUS | EXT | HOLD | IMMediate |
INTernal1-4 | TTLT0-7
:SOURce[<n>]?
TRIGger[:IMMediate]
TRIGger[:IMMediate] causes the instrument to transition to the
wait-for-sample state immediately, regardless of the trigger source selected.
Comments Instrument Must be Initiated: The instrument must be initiated (INITiate
command) and be in the wait-for-trigger state when TRIG:IMM is executed.
A “Trigger ignored” error will be generated if the instrument has not been
initiated prior to this command or if it is not in the wait-for-trigger state.
Executable when initiated: YES
Coupled command: NO
Reset (*RST) condition: None
TRIGger:LEVel
TRIGger:LEVel<channel> <voltage> | MIN | MAX sets the level on the
specified channel that can be used for internally triggering the instrument.
This command is valid only for TRIGger:SOURce INTernal1-4.
Parameters
Name Type Range of Values Default Value
voltage numeric see Comments volts