Filter
Top Products
106 Digitizers Command Reference Chapter 3
Executable when initiated: YES
Coupled command: NO
Reset (*RST) condition: NORMal mode
TRIGger:MODE?
TRIGger:MODE? queries the trigger mode setting. Returns NORMal,
MASTer or SLAVe.
TRIGger:SLOPe[<n>]
TRIGger:SLOPe[<n>] POS | 1 | NEG | 0 sets the active edge of the trigger
signal that causes a measurement to be made.
Parameters
Comments
Trigger Source Must be INTernal or EXTernal: Trigger slope is active only
when the trigger source is one of the four INTernal levels (TRIG:SOURce
INT1-4) or when the EXTernal trigger source is specified (TRIG:SOURce
EXTernal).
Two Trigger Sources: There are two trigger sources and you must designate
which source you are setting the slope. Use n = 1 for the slope of trigger
source number 1 and n = 2 for the slope of trigger source number 2. Trigger
slope defaults to n = 1 if <n> is not designated.
Executable when initiated: YES
Coupled command: TRIG:SOURce INT1-4 and TRIG:SOURce EXTernal
Reset (*RST) condition: SLOPe1 = POSitive and SLOPe2 = POSitive
TTLT pairs to SLAVe modules
MASTer MODE SLAVe MODE Sample line Trigger line
MASTer0 SLAVe0 TTLT0 TTLT1
MASTer2 SLAVe2 TTLT2 TTLT3
MASTer4 SLAVe4 TTLT4 TTLT5
MASTer6 SLAVe6 TTLT6 TTLT7
Name Type Range of Values Default Value
<n> numeric 1 or 2 none