Filter
Top Products
28 Configuring the Digitizer Modules Chapter 1
Step 3 Solder conductors to pins.
CAUTION AVOID EXCESSIVE HEAT. Excessive heat on the connector
terminals can cause damage to the connector.
Step 4 Assemble the connector.
A. Align coupling ring’s tabs with cable connector’s side notches and push
the coupling ring onto the cable connector.
B. Push the cable clamp housing forward until it locks into the connector
body and snap the two clamps into their compartments to secure the cable.
C. Push the boot all the way forward to seat tightly onto the cable clamp
housing.