Installation
1-14
CSA8000B & TDS8000B User Manual
CAUTION. Connect the keyboard, mouse, and other accessories before applying
power to the product. Connecting the accessories after powering on the
instrument can damage the accessories. Two exceptions ar e the USB keyboard
and mouse that ships with the instrument. Both can be plugged or unplugged
without first turning power off.
2. Connect the keyboard and mouse, observing the caution above. Note that the
instrument ships with a USB keyboard, which plugs into the USB port (see
Figure 1--3 on page 1--12 for location) and a USB mouse, which plugs into
the back of the USB keyboard.
NOTE. Connection of the keyboard and mouse is optional. You can operate most
features without them, using the front-panel controls and the touchscreen.
3. Connect the power cord.
4. If you have an external monitor, connect the power cord and power on the
monitor.
5. Turn the Power switch on at the rear panel. (See Figure 1--4 on page 1--13 for
switch location.)
6. Push the On/Standby switch to power on the instrument (see Figure 1--5 for
the switch location).
Switch
Figure 1- 5: On/Standby switch location
7. Wait for the boot routine and low-level self test to complete.
8. Follow any instructions on the screen.
The internal setup software will automatically configure your instrument and
install all required devices, depending on the installed accessories.