Tektronix TDS8000B Stereo System User Manual


 
Appendix A: Specifications
A-12
CSA8000B & TDS8000B User Manual
Table A- 10: Certifications and compliances (cont.)
Category Standards or descri ption
EN 61010-1/ A2:1995 Safety requirements for elect ri cal equipment for measurement
control and laboratory use.
U.S. Nationally Recognized
Test ing Laboratory Listing,
mainframe
UL3111-1 Standard for electrical measuring and test equipment.
Canadian Certif ication,
mainframe
CAN/CSA C22.2 No. 1010.1 Safety requi rements for electrical equipment for measurement,
control, and laboratory use.
Installation (Overvoltage)
Category D escription
Termi nals on this product may have different installation (overvoltage) category designations. The
installation categori es are:
CAT III Distribution-level mains (usually permanently connected). Equipment at this level is
typically in a f ixed industrial locati on.
CAT II Local-level mains (wall socket s). Equi pment at this level i ncludes appl iances, portable
tools, and similar products. Equipment is usual ly cord-connected.
CAT I Secondary (signal level) or battery operated circuits of electronic equipment.
Pollution Degree Descriptions A measure of the contaminates that could occur in the environment around and within a product.
Typically the internal environment inside a product is considered to be the same as the external.
Products should be used only in the environment for which they are rated.
Pollution Degree 2 Normally only dry, nonconductive pollution occurs. Occasionally a
temporary c onductivity t hat is caused by condensation must be
expected. This location is a t ypical office/home environment.
Tem porary condensation occurs only when the product is out of
service.
Equipment Type
Test and measuring
Safety Class Class 1 (as defined in I EC 61010-1, Annex H) - grounded product
Overvoltage Category Overvoltage Category II (as defined in IEC 61010-1, Annex J)
Pollution Degree Pollution Degree 2 (as defined in IEC 61010-1). Note: Rated for indoor use only.