Filter
Top Products
25
NAVI/AV Chapter 1 Basic Operation
➲ Removing the front panel ➞ Page 26
• When the ignition switch is turned OFF after
the LCD panel has been closed, turning the
ignition switch ON again (or turning it to ACC)
will not open the LCD panel. In this case, press
the OPEN/CLOSE button to open the LCD
panel.
• When closing the LCD panel, check to make
sure that it has closed completely. If the LCD
panel has stopped halfway, leaving it like this
could result in damage.
1 Press the OPEN/CLOSE button to close
the LCD panel.
❒ To open the LCD panel, press the OPEN/
CLOSE button again.
Setting the LCD panel
Adjusting the LCD panel angle
1 Press and hold the OPEN/CLOSE button.
The Flap Setup screen appears.
2 Press the or button to adjust the
LCD panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you keep pressing and holding the
or button.
3 Touch “ESC”.
When Flap Setup is displayed during the
navigation screen, the map screen is dis-
played.
When Flap Setup is displayed during the AV
screen, the current AV operation screen is dis-
played.
❒ If you can hear the LCD panel knocking
against your vehicle’s console or dash-
board, press the button to move the
LCD panel slightly forward.
❒ When adjusting the LCD panel angle, be
sure to press the or button. Man-
ually adjusting the LCD panel by hand may
damage it.
❒ The adjusted the LCD panel angle will be
memorized and LCD panel will automati-
cally return to this angle the next time the
LCD panel is opened.
Setting the slide back function
You can adjust LCD panel slide position to pre-
vent the display from hitting the gearstick of an
automatic vehicle when it is in P (park) position.
❒ Please be careful, as LCD panel will slide
immediately after the setting is turned “On”.
1 Press and hold the OPEN/CLOSE button.
The Flap Setup screen appears.
2 Touch “Flap Set Back”.
Touching “Flap Set Back” switches between
“On” and “Off”.