Filter
Top Products
153
AppendixNAVI/AV
Speed pulse wire is not connected.
System will start to learn without
speed pulse. Please keep in mind
that accuracy is not fully ensured
without speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Vibration is detected. Please power
off the system and check the installa-
tion. After you have checked, please
re-boot the system and press “OK”.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please power off the system and
check the installation. After you have
checked, please re-boot the system
and press “OK”.
Direction of G sensor is set incor-
rectly.
See the “Installation Manual” and set
the direction of the navigation unit
correctly.
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center.
Abnormal output is detected from
the Gyrosensor.
Note down the error code shown on
the screen. Turn off the power, and
then contact your nearest Pioneer
service facility.
This function is not available now. The screen cannot be displayed with
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
If the sensor learning status reaches
the Sensor Initializing status, the sys-
tem is ready to be used.
System detected that the vertical
angle of the installation has been
changed. Learning status for Gyro
Sensor has been initialized.
If the mounting angle of the naviga-
tion unit has been changed.
The system initializes the sensor in
order to operate it with the maximum
performance and automatically
starts re-learning.
System detected that the vertical
angle of the installation exceeds the
permission level. Please install the
navigation unit correctly.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details refer to Installation Man-
ual.)
No data available at this time. If no data is available that can be
used with the XM tuner.
Wait for a while and try the operation
again.
No XM signal. Please wait. While waiting for a response from
the XM tuner.
Wait for a while and try the operation
again.
You are in an area that cannot
receive XM tuner reception.
Move into an area that can receive
XM tuner reception.
Your current location provides very
poor reception.
Change your location.
XM updating. Please wait. Service subscription is either
XM audio only
or XM NavTraffic
stand alone.
Since the GEX-P10XMT is capable of
receiving both XM audio and XM
NavTraffic service, if you are sub-
scribed to only one or the other, the
system checks to see if you have
added another service to your
account since you last powered on
the navigation system. When you
subscribe to both services, this mes-
sage will stop appearing when you
turn the ignition ON (ACC ON).
Radio is being updated with the lat-
est encryption code.
Wait until the encryption code is fully
updated.
UPDATING The selected channel is not included
in your subscription.
Select another channel.
Radio is being updated with the lat-
est encryption code.
Wait until the encryption code is fully
updated.
Message When What to do