Filter
Top Products
3-21
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
Chapter 3 Getting Started with CMS
Menus and Toolbar
Front Panel View Popup Menus
These popup menus are available in the Front Panel view.
Device Popup Menu
You can display all switch and cluster configuration windows from the menu bar, or you can display
commonly used configuration windows from the device popup menu (see Table 3-13). To display the
device popup menu, click the switch icon from the cluster tree or the front-panel image itself, and
right-click.
Port Popup Menu
You can display all port configuration windows from the Port menu on the menu bar, or you can display
commonly used port configuration windows from the port popup menu (see Table 3-14). To display the
port popup menu, click a specific port image, and right-click.
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the “Access Modes in CMS” section
on page 3-31.
2. Some options from this menu option are not available in read-only mode.
3. Available only from a cluster-management session.
Table 3-13 Device Popup Menu
Popup Menu Option Task
Device Manager
1
1. Available from a cluster member switch but not from the command switch.
Launch Device Manager for the switch.
Host Name
2
2. Not available in read-only mode. For more information about the read-only mode, see the “Access Modes in CMS” section
on page 3-31.
Change the name of the switch.
Delete Cluster
2
3
4
3. Available only from the command switch.
4. Available only from a cluster-management session.
Delete a cluster.
Remove from Cluster
2
4
Remove a member from the cluster.
Bandwidth Graphs Display graphs that plot the total bandwidth in use.
Properties Display information about the device and port on either end of the link and
the state of the link.
Table 3-14 Port Popup Menu
Popup Menu Option Task
Port Settings
1
Display and configure port settings.
VLAN
1
Define the VLAN mode for a port or ports and add ports to VLANs. Not
available for the Catalyst 1900 and Catalyst 2820 switches.
Port Security
1
2
Enable port security on a port.