Filter
Top Products
3-18
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
Chapter 3 Getting Started with CMS
Menus and Toolbar
STP
2
Display and configure STP parameters for a switch.
IGMP Snooping
2
Enable and disable Internet Group Management Protocol (IGMP) snooping and IGMP
Immediate-Leave processing on the switch. Join or leave multicast groups, and configure
multicast routers.
802.1X
1
Configure 802.1X authentication of devices as they are attached to LAN ports in a
point-to-point infrastructure.
ACL
2
(guide mode available
1
)
Create and maintain access control lists (ACLs), and attach ACLs to specific ports.
Security Wizard
1
Filter certain traffic, such as HTTP traffic, to certain networks or devices. Restrict access
to servers, networks, or application data from certain networks or devices.
QoS
2
(guide mode available on some
options
1
)
Display submenu options to enable and disable quality of service (QoS) and to configure
or modify these parameters:
• Trust settings
2
• Queues
2
• Maps
2
• Classes
2
(guide mode available
1
)
• Policies
2
(guide mode available
1
)
AVVID Wizards
1
• Voice Wizard
1
—Configure a port to send or receive voice traffic.
• Video Wizard
1
—Optimize multiple video servers for sending video traffic.
• Data Wizard
1
—Provide a higher priority to specific applications.
LRE Profiles Set profiles for a switch.
LRE Rate Selection Set rate selection parameters for automatically assigning profiles, setting signal-to-noise
(SNR) margins, locking profiles, and qualifying links.
Port
Port Settings
2
Display and configure port parameters on a switch.
Port Search Search for a port through its description.
Port Security
1
Enable port security on a port.
EtherChannels
2
Group ports into logical units for high-speed links between switches.
SPAN
2
Enable Switch Port Analyzer (SPAN) port monitoring.
Protected Port
2
Configure a port to prevent it from receiving bridged traffic from another port on the
same switch.
Flooding Control
2
Block the normal flooding of unicast and multicast packets, and enable the switch to
block packet storms.
VLAN
VLAN
2
(guide mode available
1
)
Display VLAN membership, assign ports to VLANs, and configure 802.1Q trunks.
Display and configure the VLAN Trunking Protocol (VTP) for interswitch VLAN
membership.
Management VLAN
2
Change the management VLAN on the switch.
VMPS
2
Configure the VLAN Membership Policy Server (VMPS).
Table 3-11 Menu Bar (continued)
Menu-Bar Options Task