Filter
Top Products
B-8
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
Appendix B Working with the IOS File System, Configuration Files, and Software Images
Working with Configuration Files
• For the Trivial File Transfer Protocol (TFTP), the syntax is
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file from which to extract files.
For flash:/file-url, specify the location on the local Flash file system into which the tar file is extracted.
You can also specify an optional list of files or directories within the tar file for extraction. If none are
specified, all files and directories are extracted.
This example shows how to extract the contents of a tar file located on the TFTP server at 172.20.10.30.
This command extracts just the new-configs directory into the root directory on the local Flash file
system. The remaining files in the saved.tar file are ignored.
Switch# archive tar /xtract tftp:/172.20.10.30/saved.tar flash:/new-configs
Displaying the Contents of a File
To display the contents of any readable file, including a file on a remote file system, use the more [/ascii
| /binary | /ebcdic] file-url privileged EXEC command:
This example shows how to display the contents of a configuration file on a TFTP server:
Switch# more tftp://serverA/hampton/savedconfig
!
! Saved configuration on server
!
version 11.3
service timestamps log datetime localtime
service linenumber
service udp-small-servers
service pt-vty-logging
!
<output truncated>
Working with Configuration Files
This section describes how to create, load, and maintain configuration files. Configuration files contain
commands entered to customize the function of the Cisco IOS software. To better benefit from these
instructions, your switch must contain a minimal configuration for interacting with the system software.
You can create a basic configuration file by using the setup program or by entering the setup privileged
EXEC command. For more information, see Chapter 4, “Assigning the Switch IP Address and Default
Gateway.”
You can copy (download) configuration files from a TFTP, FTP, or RCP server to the running
configuration or startup configuration of the switch. You might want to perform this for one of these
reasons:
• To restore a backed-up configuration file.
• To use the configuration file for another switch. For example, you might add another switch to your
network and want it to have a configuration similar to the original switch. By copying the file to the
new switch, you can change the relevant parts rather than recreating the whole file.
• To load the same configuration commands on all the switches in your network so that all the
switches have similar configurations.