Filter
Top Products
Index
IN-23
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
removing source (monitored) ports 21-17
specifying monitored ports 21-15
source ports 21-4
transmitted traffic 21-4
VLAN-based 21-6
RSTP
active topology, determining
12-2
BPDU
format
12-5
processing 12-6
configuration guidelines 12-12
designated port, defined 12-2
designated switch, defined 12-2
interoperability with 802.1D
described
12-11
restarting migration process 12-22
topology changes 12-6
overview 12-2
port roles
described
12-2
synchronized 12-4
proposal-agreement handshake process 12-3
rapid convergence
edge ports and Port Fast
12-3
point-to-point links 12-3, 12-22
root ports 12-3
root port, defined 12-2
See also MSTP
running configuration, saving
4-10
S
saving changes in CMS 3-33
SC (standby command switch) 6-12, 6-23
secure addresses
adding
7-59
described 7-59
secure ports, configuring 18-4
secure remote connections 7-33
Secure Shell
See SSH
security, port
18-4
sequence numbers in log messages 23-8
sequences 10-4
table of 10-4
sequences, LRE
global
assigning
10-9
specific port
assigning
10-10
server mode, VTP 15-3
servers, BOOTP 1-3
service-provider network, MSTP and RSTP 12-1
set-request operation 24-4
settings
duplex mode
10-7
speed 10-7
set-top box, television 1-16
setup program, failed command switch replacement 28-9,
28-10
severity levels, defining in system messages 23-8
show and more command output, filtering 2-10
show cdp traffic command 20-5
show cluster members command 6-25
show configuration command 9-16
show controllers ethernet-controller command 10-5
show controllers lre commands 10-7, 10-9, 10-10
show controllers lre profile mapping 10-9, 10-10, 10-11,
10-13, 10-14
show controllers lre profile mapping command 10-8, 10-9
show interfaces command 9-13, 9-16
show running-config command
displaying ACLs
25-19, 25-20, 25-21
interface description in 9-16
shutdown command on interfaces 9-19
signal to noise ratio 10-12
Simple Network Management Protocol
See SNMP