Filter
Top Products
Status alarms and Status Alarm Severity (continued)Table 5-2:
Alarm code Status message Default severity Notes Configurable?
A011 Zero Calibration Failed:
Low
Fault
Yes
A012 Zero Calibration Failed:
High
Fault
Yes
A013 Zero Calibration Failed:
Unstable
Fault
Yes
A014 Transmitter Failure
Fault
No
A016 Sensor RTD Failure
Fault
Yes
A017 T-Series RTD Failure
Fault
Yes
A020 No Flow Cal Value
Fault
Yes
A021 Incorrect Sensor Type (K1)
Fault
No
A102 Drive Overrange
Informational
Yes
A104 Calibration in Progress
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Yes
A105 Slug Flow
Informational
Yes
A107 Power Reset Occurred
Informational
Normal transmitter behavior; oc-
curs after every power cycle.
Yes
A113 mA Output 2 Saturated
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Yes
A114 mA Output 2 Fixed
Informational
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Yes
A116 Temperature Overrange
(Petroleum)
Informational
Applies only to transmitters with
the petroleum measurement appli-
cation.
Yes
A117 Density Overrange (Petro-
leum)
Informational
Applies only to transmitters with
the petroleum measurement appli-
cation.
Yes
A120 Curve Fit Failure (Concen-
tration)
Informational
Applies only to transmitters with
the concentration measurement
application.
No
A121 Extrapolation Alarm (Con-
centration)
Informational
Applies only to transmitters with
the concentration measurement
application.
Yes
A132 Sensor Simulation Active
Informational
Applies only to flowmeters with the
enhanced core processor.
Can be set to either Informational or
Ignore, but cannot be set to Fault.
Yes
Configure device options and preferences
78 Micro Motion
®
9739 MVD Transmitters