Filter
Top Products
Procedure
1. Select a status alarm.
2. For the selected status alarm, set Status Alarm Severity as desired.
Option Description
Fault
Actions when fault is detected:
• The alarm is posted to the Alert List.
• Outputs go to the configured fault action (after Fault Timeout has expired, if
applicable).
• Digital communications go to the configured fault action (after Fault Timeout
has expired, if applicable).
• The status LED (if available) changes to red or yellow (depending on alarm se-
verity).
Actions when alarm clears:
• Outputs return to normal behavior.
• Digital communications return to normal behavior.
• The status LED (if available) returns to green and may or may not flash.
Informa-
tional
Actions when fault is detected:
• The alarm is posted to the Alert List.
• The status LED (if available) changes to red or yellow (depending on alarm se-
verity).
Actions when alarm clears:
• The status LED (if available) returns to green and may or may not flash.
Ignore
No action
Status alarms and options for Status Alarm Severity
Status alarms and Status Alarm SeverityTable 5-2:
Alarm code Status message Default severity Notes Configurable?
A001 EEPROM Error (Core Pro-
cessor)
Fault
No
A002 RAM Error (Core Processor)
Fault
No
A003 No Sensor Response
Fault
Yes
A004 Temperature Overrange
Fault
No
A005 Mass Flow Rate Overrange
Fault
Yes
A006 Characterization Required
Fault
Yes
A008 Density Overrange
Fault
Yes
A009 Transmitter Initializing/
Warming Up
Fault
Yes
A010 Calibration Failure
Fault
No
Configure device options and preferences
Configuration and Use Manual 77