Filter
Top Products
CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
D-1
Appendix D: Cleaning
Use these procedures to clean your instrument. If additional cleaning is required,
have your instrument serviced by qualified service personnel.
CAUTION. To prevent getting moisture inside the instrument during external
cleaning, use only enough liquid to dampen the cloth or applicator.
Exterior Cleaning
Clean the exterior surfaces of the chassis with a dry lint-free cloth or a soft-
bristle brush. If any dirt remains, use a cloth or swab dipped in a 75% isopropyl
alcohol solution. Use a swab to clean narrow spaces around controls and
connectors. Do not use abrasive compounds on any part of the chassis.
Clean the On/Standby switch using a dampened cleaning towel. Do not spray or
wet the switch directly.
CAUTION. Do not use chemical cleaning agents which might damage the plastics
used in this instrument. Use only deionized water when cleaning the front-panel
buttons. Use a 75% isopropyl alcohol solution as a cleaner and rinse with
deionized water. Before using any other type of cleaner, consult your Tektronix
Service Center or representative.